The High-Velocity Hurricane Zone: What It Means for Your Shutters
Two counties in Florida build to a tougher set of rules than the rest of the state. Here is what that changes for a homeowner.

The High-Velocity Hurricane Zone (HVHZ) is the part of Florida with the toughest building rules: Miami-Dade and Broward counties. Homes here are designed for higher wind speeds, with 175 mph as Miami-Dade's design wind speed for typical houses, and shutters and windows must carry a product approval for the zone.
The Florida Building Code applies statewide, but it has separate, stricter sections for the High-Velocity Hurricane Zone. If you live in Miami-Dade, those sections apply to your home.
Where it is
The HVHZ is two counties: Miami-Dade and Broward. All of Miami-Dade is inside it, from Homestead to Aventura.
What is different here
| Topic | In the HVHZ |
|---|---|
| Design wind speed | 175 mph for typical homes in Miami-Dade |
| Product approval | A Miami-Dade NOA or a Florida approval that covers the HVHZ |
| Testing | The county's impact and pressure protocols (TAS 201, 202, 203) |
| Openings on new buildings | Must be impact resistant or protected with an approved covering |
About the 175 mph number
The design wind speed is what engineers use to work out the pressure on each window and door of a building. For typical houses in Miami-Dade, the number is 175 mph.
It is not a rating stamped on a shutter. A shutter's approval lists the pressures it can take, in pounds per square foot. The installer or engineer matches those to your home, based on the building's height, its exposure, and where each opening sits on the wall. Corners see more pressure than the middle of a wall.
Be careful with any advertisement that says a shutter is "rated for" a certain wind speed. Ask for the NOA and the design pressures instead.
Want a price for your own home?
We install and repair accordion shutters across Miami-Dade County. Estimates are free and there is no obligation.
Impact tests
Openings up to 30 feet above the ground must resist the large missile test: a 9-pound piece of lumber fired at the product. Above 30 feet, a small missile test applies, because that is the kind of debris found at that height.
See what an NOA is for the tests in detail.
The HVHZ and the rest of Florida
Most of the Florida coast is in what the code calls a wind-borne debris region, where new buildings also need opening protection. The HVHZ goes further in two ways:
- Its own test protocols. Products are tested to the Miami-Dade standards described above.
- Its own approval path. A product needs a Miami-Dade NOA or a state approval that specifically covers the zone.
This is why a shutter sold in Tampa or Orlando is not automatically acceptable in Kendall or Hialeah.
Homes built before the current code
The rules above apply to new construction and to new work. An older house is not in violation because the code changed after it was built. When you add shutters or replace windows, though, the new product and its installation have to meet today's rules. See are hurricane shutters required in Florida.
What it means when you buy shutters
- The product needs an HVHZ approval. A shutter sold elsewhere in Florida may not be approved here.
- The installation follows the approval. Anchor type and spacing come from the NOA.
- A permit is required. See shutter permits.
- Plywood is not an approved product for the zone. See plywood vs. shutters.
Why the rules are this strict
Hurricane Andrew came ashore near Homestead on August 24, 1992, as a Category 5 storm. According to the National Weather Service, it destroyed or damaged well over 100,000 homes in the county. The building codes that followed, and the product testing that came with them, are the reason "Miami-Dade approved" became a standard that other places refer to.
Frequently asked questions
Is all of Miami-Dade County in the HVHZ?
Yes. The zone covers all of Miami-Dade and Broward counties.
What wind speed are Miami-Dade shutters approved for?
Approvals are written in design pressures, not wind speeds. Miami-Dade's design wind speed for typical homes is 175 mph, and the pressures for each opening are worked out from that.
Can I use a shutter that is approved for the rest of Florida?
Only if its approval specifically covers the High-Velocity Hurricane Zone.
Sources and further reading
Miami Accordion Shutters installs and repairs hurricane shutters across Miami-Dade County, including Miami, Hialeah, Kendall, Doral, Coral Gables, Homestead, Cutler Bay, Miami Beach, and nearby communities. Call (786) 201-1300 for a free estimate.